Head gasket for models with round pushrod tunnels

 2 in stock

 13022001 GU13022001 13 02 20 01
 1302 2001 1302.2001 13.02.20.01

Threaded adaptor connecting oil line to cylinder head

Fits to ENA14660

 2 in stock

 14153660 GU14153660 14 15 36 60
 1415 3660 1415.3660 14.15.36.60

Black plastic alternator cover spacer for ENA18165. Allows alternator to cool better (preventing early failure) and improves clearance on crank for alternative charging or ignition systems

 2 in stock

18001150-z 18001150 GU18001150 18 00 11 50
 1800 1150 1800.1150 18.00.11.50

Complete 950cc piston and Nikasil coated barrel kit including gudgeon pin, piston rings and circlips. Piston is low compression. This kit with Italian made piston and rings is an an alternative to Gilardoni kits which can often be in short supply.

Components for one cylinder. See ENA18102 for similar kit made by Gilardoni

 2 in stock

18060102-z 18060102 GU18060102 18 06 01 02
 1806 0102 1806.0102 18.06.01.02

O ring, used for oil filter cover

Change at every oil change

 2 in stock

1A023580

Pair of black tubular rocker cover protector bars for round and square barrel engines, these will protect barrels and rocker cover in the unfortunate event of your bike being dropped

These head protectors bolt to the head using existing rocker cover bolts, they won't fit models with fairing lowers that wrap around the cylinders (e.g. Spada) without modification. To modify simply reduce the length of the rear section of the bar to stop short of the fairing and insert the supplied grommet. These bars are supplied with a plastic grommet for each end, this will need chamfering or leaving off on round head models with bolt on rocker cover breather pipes, e.g. T3. These bars will not fit on a T3 or other model with knee pads

 1 in stock

Pair of chrome tubular rocker cover protector bars for round and square barrel engines, these will protect barrels and rocker cover in the unfortunate event of your bike being dropped

These head protectors bolt to the head using existing rocker cover bolts, they won't fit models with fairing lowers that wrap around the cylinders (e.g. Spada) without modification. To modify simply reduce the length of the rear section of the bar to stop short of the fairing and insert the supplied grommet. These bars are supplied with a plastic grommet for each end, this will need chamfering or leaving off on round head models with bolt on rocker cover breather pipes, e.g. T3. These bars will not fit on a T3 or other model with knee pads

 1 in stock

Pair of tubular chrome rocker cover protector bars for two valve engines with carbs of twin throttle bodies. These will protect barrels and rocker covers in the unfortunate event of your bike being dropped

These head protectors bolt to the head at three points using existing rocker cover bolts

 1 in stock

Polished aluminium distributor cover for models with points or electronic ignition. Alternative for plastic cover ENA14420

See SSA05025 for the screws which secure this dizzie cap

 1 in stock

14715420-z 14715420 GU14715420 14 71 54 20
 1471 5420 1471.5420 14.71.54.20

Cable for handlebar mounted decompressor

 1 in stock

 10801500 GU10801500 10 80 15 00
 1080 1500 1080.1500 10.80.15.00